maintain baner



Solar panel maintenance is important because insufficient care for solar panels can reduce the amount of energy that these panels generate for your home. Since a solar panel system needs to absorb energy from the sun, the most vital component of solar panel care is to keep the panels clean. You can usually maintain a solar panel using the same equipment that you use to wash your residential and automobile windows, as long as you provide regular care and don't allow dirt and other environmental elements from settling on the panels for too long.


water heater

Solar energy systems require periodic inspections and routine maintenance to keep them operating efficiently. Also, from time to time, components may need repair or replacement. You should also take steps to prevent scaling, corrosion, and salt.

You might be able to handle some of the inspections and maintenance tasks on your own, but others may require a qualified technician. Ask for a cost estimate in writing before having any work done. For some systems, it may be more cost effective to replace, shut off, or remove the solar system than to have it repair.


solar heater

A lead acid battery is composed of array of cells. This array of cells is known as Battery. A 12 volt Mono block battery has 6 cells (each gives 2 volts) but a 2 volt tubular battery has only one cell.The capacity of the battery to store charge is expressed in terms of Ampere hours (Ah). One Ah = 3600 coulombs. 1 Ah battery can provide 1 ampere current in 1 hour. The 100 Ah tubular battery used in Inverters can give 1 ampere current for 100 hours. Battery rating is based on the constant discharge rate for a particular time; say 10 hours, till the terminal voltage reduces to minimum. Typically a 100 Ah battery gives 5 ampere discharging current for 20 hours. During charging, the energy from the external power source causes the chemical changes in a reverse manner so that battery regains its charge

How to add distilled water to Tubular batteries used in inverters ?

It looks there is a float and a markings which goes down when the liquid level in the battery moves down. How to add the makeup water required? Can anybody give step by step process?